This manual page is part of the POSIX Programmers Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
wctob - wide-character to single-byte conversion
int wctob(wint_t c);
The wctob() function shall determine whether c corresponds to a member of the extended character set whose character representation is a single byte when in the initial shift state.
The behavior of this function shall be affected by the LC_CTYPE category of the current locale.
The wctob() function shall return EOF if c does not correspond to a character with length one in the initial shift state. Otherwise, it shall return the single-byte representation of that character as an unsigned char converted to int.
No errors are defined.
The following sections are informative.
btowc() , the Base Definitions volume of IEEE Std 1003.1-2001, <wchar.h>
Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .
|IEEE/The Open Group||WCTOB (P)||2003|