strtoul, strtoull, strtouq - convert a string to an unsigned long integer
unsigned long int strtoul(const char *nptr, char **endptr ", int " base );
unsigned long long int strtoull(const char *nptr, char **endptr, int base);
Feature Test Macro Requirements for glibc (see feature_test_macros(7)):
strtoull():XOPEN_SOURCE >= 600 || _BSD_SOURCE || _SVID_SOURCE || _ISOC99_SOURCE || _POSIX_C_SOURCE >= 200112L;
or cc -std=c99
The strtoul() function converts the initial part of the string in nptr to an unsigned long int value according to the given base, which must be between 2 and 36 inclusive, or be the special value 0.
The string may begin with an arbitrary amount of white space (as determined by isspace(3)) followed by a single optional + or - sign. If base is zero or 16, the string may then include a "0x" prefix, and the number will be read in base 16; otherwise, a zero base is taken as 10 (decimal) unless the next character is 0 , in which case it is taken as 8 (octal).
The remainder of the string is converted to an unsigned long int value in the obvious manner, stopping at the first character which is not a valid digit in the given base. (In bases above 10, the letter A in either upper or lower case represents 10, B represents 11, and so forth, with Z representing 35.)
If endptr is not NULL, strtoul() stores the address of the first invalid character in *endptr. If there were no digits at all, strtoul() stores the original value of nptr in *endptr (and returns 0). In particular, if *nptr is not \0 but **endptr is \0 on return, the entire string is valid.
The strtoull() function works just like the strtoul() function but returns an unsigned long long int value.
The strtoul() function returns either the result of the conversion or, if there was a leading minus sign, the negation of the result of the conversion represented as an unsigned value, unless the original (nonnegated) value would overflow; in the latter case, strtoul() returns ULONG_MAX and sets errno to ERANGE. Precisely the same holds for strtoull() (with ULLONG_MAX instead of ULONG_MAX).
The implementation may also set errno to EINVAL in case no conversion was performed (no digits seen, and 0 returned).
EINVAL (not in C99) The given base contains an unsupported value. ERANGE The resulting value was out of range.
strtoul() conforms to SVr4, C89, C99 and POSIX-2001, and strtoull() to C99 and POSIX.1-2001.
Since strtoul() can legitimately return 0 or ULONG_MAX (ULLONG_MAX for strtoull()) on both success and failure, the calling program should set errno to 0 before the call, and then determine if an error occurred by checking whether errno has a nonzero value after the call.
In locales other than the "C" locale, other strings may be accepted. (For example, the thousands separator of the current locale may be supported.)
BSD also has
u_quad_t strtouq(const char *nptr, char **endptr, int base);with completely analogous definition. Depending on the wordsize of the current architecture, this may be equivalent to strtoull() or to strtoul().
Negative values are considered valid input and are silently converted to the equivalent unsigned long int value.
See the example on the strtol(3) manual page; the use of the functions described in this manual page is similar.
atof(3), atoi(3), atol(3), strtod(3), strtol(3)
This page is part of release 3.44 of the Linux man-pages project. A description of the project, and information about reporting bugs, can be found at http://www.kernel.org/doc/man-pages/.