This manual page is part of the POSIX Programmers Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
siglongjmp - non-local goto with signal handling
void siglongjmp(sigjmp_buf env, int val);
The siglongjmp() function shall be equivalent to the longjmp() function, except as follows:
* References to setjmp() shall be equivalent to sigsetjmp(). * The siglongjmp() function shall restore the saved signal mask if and only if the env argument was initialized by a call to sigsetjmp() with a non-zero savemask argument.
After siglongjmp() is completed, program execution shall continue as if the corresponding invocation of sigsetjmp() had just returned the value specified by val. The siglongjmp() function shall not cause sigsetjmp() to return 0; if val is 0, sigsetjmp() shall return the value 1.
No errors are defined.
The following sections are informative.
The distinction between setjmp() or longjmp() and sigsetjmp() or siglongjmp() is only significant for programs which use sigaction(), sigprocmask(), or sigsuspend().
longjmp() , setjmp() , sigprocmask() , sigsetjmp() , sigsuspend() , the Base Definitions volume of IEEE Std 1003.1-2001, <setjmp.h>
Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .
|IEEE/The Open Group||SIGLONGJMP (P)||2003|