pam_faildelay - Change the delay on failure per-application
pam_faildelay.so [debug] [delay=microseconds]
pam_faildelay is a PAM module that can be used to set the delay on failure per-application.
If no delay is given, pam_faildelay will use the value of FAIL_DELAY from /etc/login.defs.
debugTurns on debugging messages sent to syslog.
delay=NSet the delay on failure to N microseconds.
Only the auth module type is provided.
PAM_IGNOREDelay was successful adjusted.
PAM_SYSTEM_ERRThe specified delay was not valid.
The following example will set the delay on failure to 10 seconds:
auth optional pam_faildelay.so delay=10000000
pam_fail_delay(3), pam.conf(5), pam.d(5), pam(7)
pam_faildelay was written by Darren Tucker <firstname.lastname@example.org>.
|Linux-PAM Manual||PAM_FAILDELAY (8)||06/04/2011|