libssh2_sftp_write - write SFTP data
#include <libssh2.h> #include <libssh2_sftp.h>
ssize_t libssh2_sftp_write(LIBSSH2_SFTP_HANDLE *handle, const char *buffer, size_t count);
libssh2_sftp_write(3) writes a block of data to the SFTP server. This method is modeled after the POSIX write() function and uses the same calling semantics.
handle - SFTP file handle as returned by libssh2_sftp_open_ex(3).
buffer - points to the data to send off.
count - Number of bytes from buffer to write. Note that it may not be possible to write all bytes as requested.
libssh2_sftp_handle(3) will use as much as possible of the buffer and put it into a single SFTP protocol packet. This means that to get maximum performance when sending larger files, you should try to always pass in at least 32K of data to this function.
Starting in libssh2 version 1.2.8, the default behavior of libssh2 is to create several smaller outgoing packets for all data you pass to this function and it will return a positive number as soon as the first packet is acknowledged from the server.
This has the effect that sometimes more data has been sent off but isnt acked yet when this function returns, and when this function is subsequently called again to write more data, libssh2 will immediately figure out that the data is already received remotely.
In most normal situation this should not cause any problems, but it should be noted that if youve once called libssh2_sftp_write() with data and it returns short, you MUST still assume that the rest of the data mightve been cached so you need to make sure you dont alter that data and think that the version you have in your next function invoke will be detected or used.
The reason for this funny behavior is that SFTP can only send 32K data in each packet and it gets all packets acked individually. This means we cannot use a simple serial approach if we want to reach high performance even on high latency connections. And we want that.
Actual number of bytes written or negative on failure.
If used in non-blocking mode, it returns LIBSSH2_ERROR_EAGAIN when it would otherwise block. While LIBSSH2_ERROR_EAGAIN is a negative number, it isnt really a failure per se.
If this function returns 0 (zero) it should not be considered an error, but simply that there was no error but yet no payload data got sent to the other end.
LIBSSH2_ERROR_ALLOC - An internal memory allocation call failed.
LIBSSH2_ERROR_SOCKET_SEND - Unable to send data on socket.
LIBSSH2_ERROR_SFTP_PROTOCOL - An invalid SFTP protocol response was received on the socket, or an SFTP operation caused an errorcode to be returned by the server.
|libssh2 0.15||libssh2_sftp_write (3)||1 Jun 2007|